Low Force Universal Testing Systems

Universal Testing systems in standard force capacities from 1,000 pounds to 100,000 pounds. All MTI systems absorb  our powerful Intel Core i5 Pentium based Data Acquisition/Analysis/Control System as an integrated part, resulting in a totally automated materials testing system. All load frames are make  to exact tolerances and utilize precision ball screw drives, ground linear guide rods and bearings, and high-strength steel construction to cover  accurate and accurate velocity control and positioning capability.

 

Crosshead velocity is computer controlled and is nearly endlessly variable over the entire speed range of the system. All mid-force range floor model systems are constructed to give  for both tension and compression loading in either test bay —that is, either above or below the moving crosshead — as show here. The testing fixtures and load cell can be joint to any of the four crosshead surfaces to insure maximum capability and serviceability.

 

Low force load frames are generally conformed as table-top systems. These Universal Testing Systems  provide the same performance capabilities as our larger floor model units when high force capacity is not a requirement.

 

Another indivisual construction feature of all MTI mid-range floor models frames with dual test bay capability is the fusion of a suitably sized through hole in both load-bearing surfaces of the moving crosshead. The Universal Testing Systems load cell can then be positioned on the  crosshead (either surface) and load fixture attachment rods can project simultaneously into both test bays. This permit  for easy setup of two totally different types of tests without having to remove and reposition hardware on a frequent basis. You can simply do  a tensile test in the upper bay and then quickly execute a compression test or a bending test below the moving crosshead of the testing machine without adding or removing your fixtures.